Every software package contains a full set of examples suitable for that version and are installed with the software. If you see examples here that are not in your installation you should consider updating to a later version of the software. These examples can be used by beginners and advanced users for product evaluation, teaching purposes, and self-training.

Required Modules

Victory Process

• 2D Stress

This example demonstrates bending of a-IGZO TFT structure to test its flexibility. The simulation shows device bending over a cylinder resulting in bending and bowing deformations. The structure is built in Victory Process.

Using “CYLINDER.CX ” & “CYLINDER.RADIUS ” parameters in STRESS statement, and center and radius of cylinder is set. “CYLINDER.ANGLE ” specifies the angle for partial bending over the defined cylinder. This is a clockwise angle starting from the top of the outer surface of the cylinder defined by this angle. If not specified, the whole bottom surface of the structure will contact with the cylinder.

Setting negative and positive values to “CYLINDER.ANGLE “, the example demonstrate bending and bowing of the device.

Images