Examples

Home > Search Results For

Examples

Know how your circuit behaves across process variation before silicon tells you, with Monte Carlo-accurate results up to 30X faster.

Resources Hub
Products Hub

1 week ago

VRCx_ex27.in : Invoking Alternative Linear Solvers

Every software package contains a full set of examples suitable for that version and are installed with the software. If you see examples here that are not in your installation

1 week ago

001_Sweep_table_lookup : Table lookup for output level

Requires: SmartSpice & Smartview Minimum Versions: SmartSpice 4.6.5.R An E element voltage source (VCVS) can be used with a look-up table of values to change the output level. In this

1 week ago

002_Damped_Sinewave : Decaying Sinewave source

Requires: SmartSpice & Smartview Minimum Versions: SmartSpice 4.6.5.R A single SmartSpice element can be used to provide a decaying sinusoidal waveform. The input deck is a SPICE file containing the

1 week ago

003_FM_Source : Frequency Modulated Source

Minimum Versions: SmartSpice 4.6.5.R The input deck shows you how to produce a single element that behaves as a Frequency Modulated (FM) source. The Waveform results show how the final

1 week ago

004_FM_Source : Jitter simulation Source

Minimum Versions: SmartSpice 4.6.5.R The input deck shows you how to produce a single element that behaves as a Frequency Modulated (FM) source. If the modulation is small you can

1 week ago

005_AM_Source : Amplitude Modulated Source

Minimum Versions: SmartSpice 4.6.5.R The input deck shows how you can setup a single voltage source element to have a Amplitude Modulated sinewave output. A plot of the waveform shows

1 week ago

006_Logical_Operator : Logical output level

Minimum Versions: SmartSpice 4.6.5.R The inputdeck shows how to use an E element (VCVS) with a logical condition to set the output level given a variation in input level between

1 week ago

007_Logical_operator_limited : Logical limited output level

Minimum Versions: SmartSpice 4.6.5.R The input deck shows how to use an E element (VCVS) with a logical condition (similar to example 5) to set the output level given a

1 week ago

008_Noisey_Vsource : Noise Source

Minimum Versions: SmartSpice 4.6.5.R The first input deck shows how a nominal 10 volt supply can be specified with a noisey characteristic to see how the rest of the circuit

1 week ago

009_Source_from_waveform : Source from simulation waveform

Minimum Versions: SmartSpice 4.6.5.R The first input deck is run and and then you can extract a waveform as a result of the simulation and use this waveform to make