Requires: SmartSpice & Smartview Minimum Versions: SmartSpice 4.6.5.R An E element voltage source (VCVS) can be used with a look-up table of values to change the output level. In this

Requires: SmartSpice & Smartview Minimum Versions: SmartSpice 4.6.5.R A single SmartSpice element can be used to provide a decaying sinusoidal waveform. The input deck is a SPICE file containing the

Minimum Versions: SmartSpice 4.6.5.R The input deck shows you how to produce a single element that behaves as a Frequency Modulated (FM) source. The Waveform results show how the final

Minimum Versions: SmartSpice 4.6.5.R The input deck shows you how to produce a single element that behaves as a Frequency Modulated (FM) source. If the modulation is small you can

Minimum Versions: SmartSpice 4.6.5.R The input deck shows how you can setup a single voltage source element to have a Amplitude Modulated sinewave output. A plot of the waveform shows

Minimum Versions: SmartSpice 4.6.5.R The inputdeck shows how to use an E element (VCVS) with a logical condition to set the output level given a variation in input level between

Minimum Versions: SmartSpice 4.6.5.R The input deck shows how to use an E element (VCVS) with a logical condition (similar to example 5) to set the output level given a

Minimum Versions: SmartSpice 4.6.5.R The first input deck shows how a nominal 10 volt supply can be specified with a noisey characteristic to see how the rest of the circuit

Minimum Versions: SmartSpice 4.6.5.R The first input deck is run and and then you can extract a waveform as a result of the simulation and use this waveform to make

Minimum Versions: SmartSpice 4.6.5.R The input deck contains 2 PWL sources driving 2 seperate simple passive circuits. Source and run the input deck and a transient simulation will be run.