Requires: SmartSpice & Smartview

Minimum Versions: SmartSpice 4.6.5.R

Two sources can be used to give a variety of shaped Sine Wave cycles ranging from a ramp up, a constant level, a phase change and even a burst of Sinewave cycles.
In these example the sinewave can be made to change phase or be a burst of cycles.

The
input deck is a SPICE file that allows the output waveform to be offset in phase compared to the input waveform as show in this
waveform
plot where there is a 180 deg. shift in output waveform.

The
input deck is a SPICE file that allows a burst of cycles in the output waveform to be offset in phase compared to the input waveform as shown in this waveform
plot
where there is a burst of sine wave cycles in the output waveform.

run the simulation, Source the input deck and press the green run button. When the simulation completes, you can see the relevant output waveforms.

Graphics

Input Files

sine_delay.in

* Test input deck
*************************cs

****** PWL shaping
V2 n2 0 0 pwl (0,0  99.9u, 0 100u,1 200u,1 200.01u,0 )
R0 n2 0 1
****** Sine Source
Vsin_va vsin_va 0 DC 0 SIN(0 "v(n2)" 0.1MEG 0 0 180)
R1 vsin_va 0 1

.TRAN 10n 300u

.PROBE v(vsin_va) v(n2)

.END

sine_burst.in

* Test input deck
*************************cs

****** PWL shaping
V2 n2 0 0 pwl (0,0  99.9u, 0 100u,1 200u,1 200.01u,0 )
R0 n2 0 1
****** Sine Source
Vsin_va vsin_va 0 DC 0 SIN(0 "v(n2)" 0.1MEG 0 0 180)
R1 vsin_va 0 1

.TRAN 10n 300u

.PROBE v(vsin_va) v(n2)

.END

012_Sine_Burst

[an error occurred while processing this directive]